Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Why am I asking an ESX question on a Cisco Community. Plain and simple...Cisco and Cisco folks support VMware better than VMware support does.
I am also going to risk the whole supported vs. unsupported discussion.
My root question> Has anyone upd...
Regarding PnP, are there a downloadable package of plug and play templates for the PnP app in APIC-EM. All of the documentation regarding this app references Prime and that the templates are imbedded in Prime. I'm not seeing default templates like ...
Hello All, Hope your day is going well.
I manage a Flexpod environment that was installed roughly 3 years ago. At the time It was 3ea. chassis, 2ea. Nexus 5k, 20ea. B200 M3 blades all running ESXi 5.0, UCS Firmware 2.0 1(c), NetApp FAS etc. We hav...
I am working on a 4 site IWAN - PFRv3 install. This is currently in lab. I thought I had it all working but when I started generating some traffic for testing I found that all traffic paths are using the same tunnel. The domain master exist cli sh...
HI All,
I'm working on a PFRv3 / IWAN implementation. It is currently in a lab state. Four sites and each site has dual routers. HUB-R1 is MC / BR (Tunnel /DMVPN 100), HUB-R2 is BR (Tunnel/DMVPN 200). Each of the MC routers on each site all log ...
I use Image Builder /PowerCLI to further customize the the Cisco OEM image. You can remove the old (or too new) drivers and add drivers that match the Cisco firmware you are using.
https://pubs.vmware.com/vsphere-50/index.jsp?topic=%2Fcom.vmware.vsp...
I did not know specifically about 2.2(7b). That in itself does not solve the issue for me. Basically I am also stuck on ESXi 5.5 GA. U1 through U2 are documented as being supported by all parties but tickets into TAC for communication issues etc t...
I was so focused on your reply from the other post I didnt see this reply. Reposting the resolution here.
The Devil is in the details. Your reply helped me focus and discover the root cause, so thank you very much. I was only seeing RX in the Initi...
The Devil is in the details. Your reply helped me focus and discover the root cause, so thank you very much. I was only seeing RX in the Initial State. TX was Reachable. Not sure how that added up to me checking the routing config but it did. On...
I see in the 'show domain...channels' cmd that all of the tunnels over MPLS2 are provisional state as 'initiated and open' but the operational state is 'not-available'
Now to figure out why.