Hi all, looking at documentation I found that exists a graphic interface called something like "zone configuration tool" or Fabric manager software which would be useful to configure fabric zones in the nexus 5000. Where can I find it? Is it included in nexus? Is it freely downloadable? Thank You Regards Mauro ... View more

Hi All, I've a 857 router with an ADSL connection with dynamic IP. Now I would like to add a 3G connection to my network to increase availability in case of any problem with the ADSL line. I was asking myself if it was possible to add a 3G router to the network and use BGP to control failover between ADSL and 3G. Of course I've no control to ADSL line such as I've no control to 3G network. ADSL is directly connected to my 857 router and 3G router would be attached to a port of it. Thank You Best Regards Mauro ... View more

Hi all, I have a 877W router. Unluckily WiFi signal in my house isn't so good in all rooms where I need to use it both for long distance and for walls. Does it exist a signal expander that I can put around in my house which catches and repeats the signal coming from my router? I cannot connect it to my router with a cable so I need a repeater completely "wireless". Thank You Best Regards Mauro ... View more

Hi all, i'm new with cisco equipment. I have a 877 ADSL router. I tried to configure it for my ADSL but it seems it doesn't recognise my carrier. If I put line cable in another ADSL router it works fine but when I switch it back to my cisco 877 nothing happens. Led CD on front panel still blinks. Could you help me? Thank you RGDS Mauro P.S. These are my ATM0 and Dialer0 config: ATM0 is initializing, line protocol is down Hardware is MPC ATMSAR (with Alcatel ADSL Module) MTU 4470 bytes, sub MTU 4470, BW 4608 Kbit, DLY 80 usec, reliability 255/255, txload 1/255, rxload 1/255 Encapsulation ATM, loopback not set Encapsulation(s): AAL5 AAL2, PVC mode 10 maximum active VCs, 1024 VCs per VP, 0 current VCCs VC Auto Creation Disabled. VC idle disconnect time: 300 seconds Last input never, output never, output hang never Last clearing of "show interface" counters never Input queue: 0/224/0/0 (size/max/drops/flushes); Total output drops: 0 Queueing strategy: Per VC Queueing 5 minute input rate 0 bits/sec, 0 packets/sec 5 minute output rate 0 bits/sec, 0 packets/sec 0 packets input, 0 bytes, 0 no buffer Received 0 broadcasts, 0 runts, 0 giants, 0 throttles 0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort 0 packets output, 0 bytes, 0 underruns 0 output errors, 0 collisions, 0 interface resets 0 output buffer failures, 0 output buffers swapped out Dialer0 is up (spoofing), line protocol is up (spoofing) Hardware is Unknown Internet address will be negotiated using IPCP MTU 1500 bytes, BW 56 Kbit, DLY 20000 usec, reliability 255/255, txload 1/255, rxload 1/255 Encapsulation PPP, loopback not set Keepalive set (10 sec) DTR is pulsed for 1 seconds on reset Last input never, output never, output hang never Last clearing of "show interface" counters 00:12:53 Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0 Queueing strategy: weighted fair Output queue: 0/1000/64/0 (size/max total/threshold/drops) Conversations 0/0/16 (active/max active/max total) Reserved Conversations 0/0 (allocated/max allocated) Available Bandwidth 42 kilobits/sec 5 minute input rate 0 bits/sec, 0 packets/sec 5 minute output rate 0 bits/sec, 0 packets/sec 0 packets input, 0 bytes 0 packets output, 0 bytes ... View more