Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
our VCS stopped working and we are trying to re-install the software using the SCP procedure.
The problem is we are getting the answer "Release Key invalid".
So we did the factory-reset command but we got a similar answer:
"Failed to initialize ...
Hi,we have a BE6000 with 40 VOIP phones registered, and we use a 2900 as gateway for E1 and GSM connection.So when a VOIP phone dial an external number, BE6000 send the call to ISR and ISR use Dial Peers to call through E1 port or GSM FXO.I need to c...
Hi, we tried to implement collaboration edge in our company.For both VCS everything is configured with no alarms, but it is not working when the client is outside the company.Inside the company the Jabber register and connect to the CUCM perfectly, ...
I have a similar problem. My CUCM has just 1 Telepresence Room license installed.We replaced the codec last year, but my technician just added the new codec in CUCM, without removing the old one. So we worked with license exceeded for few months (2 T...
It should be, but it doesn`t work well. We had big problems with certificates.
I don`t understand, why it`s so simple register a SIP codec like SX10 or SX20 through Collaboration Edge, and it`s so hard to do same thing with DX650??
We are using today...
Hi, I have a similar problem, a MacBook in our network is being shunned many times per day by our ASA.
Every times this MacBook stop acessing internet the command show shun on CLI gives me the IP address of this computer, so we perform a no shun to f...
