Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, I currently have two physical links connecting one data center to another. These are both 10Gb links and I have manually set the cost to the primary link to '1' and the secondary link to '10'. My question is, if I set the secondary link to '...
Hello, I currently have a DMVPN configuration with an isakmp key that is used for all spokes. Is there a way to create a key per spoke or another method of configuring security per spoke so if someone leaves the company I can remove config from the ...
Hello,I recently configured a DMZ Anchor controller and both control and data paths are showing 'up'. When a user connects the the WLAN they are receiving an IP address from the foreign controller interface rather than the DMZ anchor which is config...
Hello,I recently installed a 5508 controller with 3602i APs...I appears that my a/n radios are present, but are showing down. I checked the network settings under "Wireless" / "802.11a/n/ac" /Network and they appear to be enabled. How would I enabl...
Hello,I am unable to find a command similar to the "ntp access-group" command available in Nexus 7000s. What is the command for Nexus 5548s?Thank you,Scott
Do you have your VLAN priority configured on each Nexus? Can you attach the output from "show spanning-tree summary" and "show spanning-tree detail | inc topology"
Thank you Ashish...DHCP Proxy is enable on both the Anchor and Foreign controllers. I am working to get both controllers on the same version of code to see if that helps.
