My coworker and I wanted to start getting into Network Automation, so we asked our server guys for a virtual server to run Linux, where we can install and learn Ansible. After it was done, I thought they would just maintain it like all the others, bu...
I am running some recently released system updates on my DNA Center and it said it should take about an hour. It's been over 3 hours now and still only at 77% in Maintenance Mode. I want to close out of this browser and go home, but I'm not sure if...
I have an IP SLA, Setup to reroute my traffic from Site A to an alternative location (Site B) if pings to my ISP fail for 30 seconds. My question is: In my situation where I was tracking an ICMP Echo reply from our ISP, I ran into a rather rare sit...
Did you ever get a resolution to this problem? I am trying to use a GLC-LH-SMD SFP in my 9500-48Y4C and have the same problem, it's not recognizing it at all!
Thank you Leo for your response. I definitely see the experience in your answer and completely understand now that this will go much smoother if I take over it and not have to worry about them screwing anything up. Thank you and I appreciate it.
Thank you for your reply and advice. I will get started on this now. I was hoping not to sound like I was complaining too much, because I just didn't know. In 20 years of IT, this is the first time, I've run into this and I appreciate your input. ...
Thank you to everyone for your replies. My version is 2.1.2.5. I literally ran all the updates starting at around 12:30pm and didn't think it would take that long, but yeah, after 4pm I realized I was wrong. I had to leave before it was finished, ...
Thank you very much for the reply. I agree with your response and have pretty much narrowed it down to 1 of 3 options:1. Manually shut down the interface going out to the SITEA FW2. Manually remove the default Route to the SITEA FW3. Get Crazy with E...
