About m-geisler

m-geisler · 07-28-2017

Hello Everyone, Just trying to get an xconnect between two 3650 to work, but I can not ping between the customer sides. I think the MPLS/LDP part is fine as it shows UP on both sides: R#sh mpls l2t vc Local intf Local circuit De...

m-geisler · 07-13-2017

Hello, Is it possible to control the front panel LEDs via CLI/HTTP/(TCL?/Python?) or to read the current status? I've got some configured, but unlabled 3650 in a ring and want to find out which switch is which without pulling cables. The only other...

m-geisler · 05-15-2014

Hello Support Community!I have a UCS 540 and wnat to connect analog phones via SPA112 ATA. Unfortunately this combination is not officially supported, but several posts indicated that it is possible.If anyone has an idea or a solution that would be g...

m-geisler · 01-29-2009

Hello!I tried to find the radiation pattern for the 1140 AP, but no luck so far.Anybody knows where to find it or can send me a copy?ThanksMike

m-geisler · 03-31-2008

Is it possible to configure an indoor mesh with 1240 APs and 2006 Controllers?ThanksMichael

m-geisler · 07-28-2017

Hi Paul, Thanks again. WE didn't get any visual or acoutic clues, but one of the commands reloaded the 3650. Uuups Ithink the fingers were faster than the eyes(brain?) So the practical part is solved. But.... I still want a way to make a router raise...

m-geisler · 07-14-2017

Hi Paul, thanks again. My problem is: which physical box is which remote session? I can cli to all boxes but I don't know on which physical device I am! As in is this prompt the third switch from the left or the eight from th...

m-geisler · 07-14-2017

Hi Paul, Thanks for your help, and maybe I was not clear what I need. I am looking for a way to identify an individual Switch (not in a stack). My problem: Someone cabled and configured a set of switches, but did not affix a lable. The cabling is ide...

m-geisler · 12-02-2015

Hi Darren, if you configured only the password in 'line vty 0 4' than it should not ask you for a username! Or did you configure : line vty 0 4 login local in that case you will need: username admin password abc123 in the global config...

m-geisler · 02-27-2015

Hi lkrol,seems you are out of luck!" Serves only incoming calls from the PSTN"Quote from:http://www.cisco.com/c/en/us/products/collateral/routers/2600-series-multiservice-platforms/product_data_sheet09186a00800921e7.htmlSo it also seems to be a softw...

Member Since	‎01-09-2003 09:15 AM
Date Last Visited	‎08-17-2018 10:33 AM
Posts	48
Total Helpful Votes Received	14

User Statistics

User Activity

MPLS XConnect on 3650

3650 Front panel LEDs programming /reading

UCS 540 and SPA 112 ATA

Radiation pattern for 1140?

Indoor MESH

Hi Paul,

Hi Paul,

Hi Paul,

Hi Darren,

Hi lkrol,seems you are out of