About dmh

dmh · 08-10-2020

So I understand the radios start on a specific channel and then update but it's been over 24 hours and the 5Ghz radios are all on different channels but the 2.4Ghz radios are all on channel 1. The APs are all in 1 building across 5 floors.Standard in...

dmh · 10-27-2009

Is it possible to terminate non-web-auth WLANs on an anchor controller?For example, you want to segregate particular WLAN access but still have encryption using WPA2-PSK or WPA2-ENT with 802.1x etc.Thanks.

BAT users and phones insert - help!!! · 02-25-2005

I'm using BAT 5.0.2 with CCM 4.0.2 and can't get a 1 line csv user and phone to insert. It validates fine but gives a message about lines and speed dials not matching the phone template.I've tried a 7940 and 7960 phone template with 0-2 lines and 0-1...

dmh · 09-21-2025

What about policy and tags for the cloned WLAN and Policy? Do they get added to the same policy for the anchor that broadcasts SSIDs or can you just create another policy that ties them together as the AP etc association doesn't apeear (to me) to mat...

dmh · 08-11-2020

Sorry, I misread your message.I will check the release notes and give it another 24 hours and might upgrade then.

dmh · 08-11-2020

26.6.1 - sounds like upgrading wouldn't help

dmh · 08-11-2020

The APs are close enough to overlap for roaming support and they can hear each other.In fact, the dashboard says the interference is coming from the other MR46 APs on the same channel!The Cisco WLC solution this is replacing was using different chann...

dmh · 03-22-2018

You can use SNMP to poll the ISE appliance and CIMC for the information you are looking for.See the following community post for details.Re: Monitoring ISE health using SNMP Polling

Member Since	‎05-20-2003 04:40 PM
Date Last Visited	‎05-12-2026 05:54 PM
Posts	28
Total Helpful Votes Received	21

User Statistics

User Activity

MR46 2.4Ghz radios all still on channel 1 after 24 hours

non-web-auth guest authentication with an anchor controller

BAT users and phones insert - help!!!

Re: 9800 Auto-Anchor with local APs and SSID

Re: MR46 2.4Ghz radios all still on channel 1 after 24 hours

Re: MR46 2.4Ghz radios all still on channel 1 after 24 hours

Re: MR46 2.4Ghz radios all still on channel 1 after 24 hours

Re: how to check ISE hardware information