Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have 1800S Sensor Image Version 2.2.2.0 provisioned with wired backhaul to DNAC version 2.1.2.4When sensor is connected on subnet with DHCP Option 43 for the DNAC, I'm able to login to console and SSH with the SSH password configured in DNAC.When ...
Customer side Metro 3400 switch:Port is 100Mb, Vlan 80 is 80MbCIR, Vlan81 is 10MbCIRwant to shape each vlan down to CIRwhat is best configuration to do this? Here is what I tried...class-map match-all vlan81 match vlan 81class-map match-all vlan80...
Any recommendations on how to config a network listfor a LAN-to-LAN tunnel for ALL traffic?I can make it work for specific routes with thereverse mask but I cannot get it to take 0.0.0.0/0.0.0.0 or 0.0.0.0/255.255.255.255Customer wants ALL destinati...
Thank you, this is helpful. The Sensor provisioning documentation needs to make that clear.This is unfortunate because our DNAC covers a large amount of subnets. We will likely need to use the pnpserver DNS option instead.I am able to console and S...
Same problem, very loud fans and was taking errors on Fan 3 and Fan 4. I popped the cover and someone had apparently replaced the power supply and did not reconnect Fan 3 and Fan 4, so Fan 1 and Fan 2 were running at 25,000RPM! It is much quieter...
thank you!Your advice worked perfectly for marking the input traffic. Now I am unable to shape the output traffic the way I want. Since this is 100Mb FastEthernet interface the error message is that I can only shape to 50000000here is config I wan...
I upgraded from v4.1.5 to v4.1.7 today and still sameproblem.On a new network list, when I try to enter:0.0.0.0/255.255.255.255 or 0.0.0.0/0.0.0.0I get the following popup message:0.0.0.0/255.255.255.255 may not have a valid Wildcard MaskWildcard ...
