Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,in FMC 7.4.3 we use Admin external auth with Active Directory (LDAPs).AD Admin says FMC uses NTLM and we have to change to Kerberos.I can't find Kerberos mentioned in FMC Admin documentation.Is it possible to change to Kerberos?regards,Thomas
Hi,I upgraded an IE3200 from IOS XE 16.10.x to 17.12.xSince I haven't found a special upgrade path I thought this would be ok.Is there a special upgrade path from 16.10.x to 17.12.x?Now the switch boots 17.12.x, shows following an reboots *Jan 7 22:...
Hello,i've updated a VG310 from 15.6.3M6 to 15.9.3M9.Since then after every reboot "mgcp fax t38 inhibit" shows up in running-config. I don't want that config parameter.After a "no mgcp fax t38 inhibit" and save to startup-config it's gone but after ...
Hello,I'm running CUCM 12.5, CUP 12.5, CUC 12.5, UCCX12.5 and I want to upgrade to 15.0I'm reading Upgrade and Compatiblity Guide.I have HCS UCM, HCS Unity Connections Smart licenses running until 2025 with no Version mentioned.Can I just Upgrade CUC...
Hello,I googled but didn't find anything.At the WSA Switchport I can see that my WSA is using most of my Internet Bandwidth.Is there a way to see Top Talkers (Device/User) in MBit/s?Please tell me how.
I managed to factory default and install 17.3.6 with no rebooting.But at boot it shows*Jan 8 04:16:28.409: PHY-EMI: Disable link failed for phy port 0
*Jan 8 04:16:28.409: PHY-EMI: Fix failed for phy port 0
*Jan 8 04:16:28.409: PHY-EMI: Enable lin...
I can boot Emergency Recovery IOS XS 16.12 from the switch.It does not reboot, but int gi1/1-10 are not shown. Only vlan1.I booted 17.12.04 from usbflash and did a factory default.Installed 17.12.04 again -> rebootsLED of gi1/1, 1/2 and 1/4 are solid...
