I have connection between cisco 6513 core switch and 3560x. The connection is from, cisco 6513 switch with network module (WS-X6704-10GE) on slot number 11 to Cisco C3560X with network module (C3KX-NM-10G). The SFPs that used are XENPAK-10GB-LR...
Hi, Is it possible to block outgoing calls based on DN from which call is orginated ... ? Or based on source IP address, in cme (Version 8.6) with h.323 voice gateway..? My scenario is Site A with CME and Voice Gateway (8 fxo port) and Site B wit...
Hi allWhen I configure bgp ,i am getting errorThe below is the configuration. ??interface GigabitEthernet0/0 ip address dhcp duplex half speed auto!interface GigabitEthernet0/1 ip address 10.1.0.2 255.255.255.252 duplex auto speed auto!router bgp 646...
Hi All, I am using a 2811 Router with NM-16ESW Swith Module in a branch, OSPF is the routing protocol Switch Module's Fa0/1 is used as Primary connection (with cost 1) and Router's Fa0/0 is used as backup connection (with cost 100).Do I need to...
Hi All, My CUCM version is "Version: 6.0.1.2000-3". And I am trying to install a device pack (version: cmterm-devicepack6.0.1.3129-1.cop.sgn) for supporting phone 7965. I trying installing by remote option usinf sftp. Everything is fine upto downla...
Reza, the switches are not connected directly, its going through SM fiber patch panel. With deferent patch cord and different X2 module (got 4 switch to connect) all with same result. If both sides of interface given "no shut", then it will work prop...
Is it possible to map fxo port to specific number of DNs which are located in another site that connected through WAN, by using answer-address...? If possible can you please show an example.
Hi Peter,I am sending the Diagram and config of Router and Switch module, Actually I have 3 Connections to the ONT( Fa1/0/10, Fa1/0/11,Fa1/0/12) and Back up (Router's Fa0/1)to VSAT,I dont have much experience in routing.Pls helpregards