Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HiI've been upgrading two switches in my lab and have come across this error. It came up when I downloaded Cisco Network Assistant. The error hasn't come up on my other switch, at the moment its just plugged into a standard socket at home. Any he...
HiI have a simple question, I have some routers at home for lab practice. When I reload one of them I always get this message:System Bootstrap, Version 11.3(2)XA4, RELEASE SOFTWARE (fc1)Copyright (c) 1999 by cisco Systems, Inc.TAC:Home:SW:IOS:Speci...
HiI have two Cisco 2950 switches and some cisco 2610 routers and am trying to follow a lab exercise in my CCNA sybex book concerning VTP.When I try and configure the VTP server side of things on the switch I get the following message after trying to ...
HiAm working through my CCNA book and i've come upto VLAN. AT home I am trying to follow one of the lab exercises. The exercise basic wants you to configure two Cisco 2950 switches so that you can ping from one to the other.Below are the commands w...
Hi RajuPlease see the link below it has all the info and config examples you requirehttp://www.cisco.com/en/US/products/sw/iosswrel/ps1818/products_configuration_example09186a0080204528.shtmlThanksJonathan
Hi GPI simply had the 2950 connected to my laptop no RPS. The switch was just plugged into a normal floor socket. I then connected by CNA and the alarm came up.Thanks
UDP Port 0 and TCP Port 0 are reserved.From the log looks like some type of port scan?In your logs did you have any messages regarding access-lists?Cisco access lists report port 0unless a port is explicity mentioned in an access list.That is, coding...
I think cost is one thing to consider, it is more expensive to do the two exam route.Also if you take the two part exam your are more likely to get more questions on certain topics.
