When using asa's for cleint vpn, then passing off to AD servers, after one incorrect attempt the AD account is locked. Has anyone seen this occurance and is there a fix ?
3660 works fine with 24 mb flash, put in new tested flash, tryed 2 sets (2 x 64), still getting no magic number. TAC says its bad flash, the flash tests clean ? Anyone have this issue before ?
What are the steps to allow credientals to pass to another router, Example. I telnet to router a, I then need to telnet to router b, is it possible to not authenticate again ?
Avi, If this is an internet design, you will have to Nat the egress traffic at some spot. The customer firewall as an example will see the traffic as out of state just for starters if the return traffic comes from a diffrent IP. A load balancer is th...
I agree with the other note, most carriers are just handing off a layer 2 handoff. Make sure you and the carrier in question talk about the spped and duplex you both are using. Watch both sides, swtich and router for errors, the errors will tell you ...
