Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear All,
I am seeing lot of Input Errors, this is between LAN uplink of Router port GE 0/1 to Cisco Switch 2960 Gig 1/0/6, is this input errors and overrun is normal between the LAN uplink? Below configuration for reference, I am seeing lot discon...
Dear All,
Can you please tell me is it possible to use Cisco 891F-K9 on the connection from ISP is VDSL2, I have changed the ISP modem configuration into Bridge mode and then configured Dialer interface , but I am not getting IP from from ISP, it i...
Hi
I dont know much about Cisco Jaber, the thing is I have Cisco IP Phone configured on my Laptop, I wanted to use the Softphone application on my iphone, I have downloaded Cisco Jaber from Play Store, under Jaber Advanced Settings - Phone Services -...
Hi, I have newly configured Anyconnect with LDAP authentication, while trying to login on Anyconnect I get the below error. I have different profiles with authencating different Domain Controller is this could be the reason? 6Oct 02 201715:03:4972500...
Hi, When I connect Anyconnect, I am getting the below error, please advise 13:29:45 Contacting xxxxxxx.13:29:55 User credentials entered.13:29:56 Establishing VPN session...13:29:56 The AnyConnect Downloader is performing update checks...13:29:56 Che...
Hi Paul,
No I am not using PPoE, it is LAN - LAN, the Switch and router port are connected as LAN, not in WAN. Please refer to my configuration in my original post
Thanks
Hi Rajan,
The URL you gave has good details, but it doesn't match with my CCM, our version is below one, may be ours is old one, even I cant see the "Cisco Dual mode for iPhone, could be because ours is old version?
Cisco Unified CallManager A...
Hi
I dont know much about Cisco Jaber, the thing is I have Cisco IP Phone configured on my Laptop, I wanted to use the Softphone application on my iphone, I have downloaded Cisco Jaber from Play Store, under Jaber Advanced Settings - Phone Services -...
Hi Richard,
it was issue with the missing following line in the config "ldap-scope subtree", after adding this one the authentication worked fine
aa-server Anyconnect protocol ldapaaa-server Anyconnect (inside) host 10.47.20.21 ldap-base-dn DC=xx...
