Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,We have a call center environment, which has around 100 users,we are cuurently using Cisco Call manager version 4.0 (Windows based.However we would like increase the user count in the near future,Moreover we want to monitor Agent status ?measu...
Hi All,We have around 1600 users in our Organisation those are spread across 4 different buildings which are connected through 45Mbps WAN links. We have to Implement a MAC address based authentication scheme for our users.I came across some of the co...
12.3 VersionHi all,i am configuring site-to-site & RVPN on Cisco 2811 ISR router.My site-to-site tunnel is up and running file no issuesBut i am facing difficulties with my Remote vpn the Rvpn tunnel is up i am able to send the traffic(to the LAN int...
Hi All,I am doing this in a testing environmet I have configured BGP between two routers (in same AS).i have changed the router ID values in R1 & R2But R1 is the only router which is starting the tcp session .Can some one explain this ?R1#debug ip pa...
Hi all,I am planning to configure multiple site-to-site tunnels cisco 2811 ISR router is it possble ?if possible how we can bind the tunnels with the interface .in the normal way like r1(config)#interface s1/0r1(config-if)#crypto map R1r1(config-if)#...
Hi Juan,Thanks for your reply, Do i need to upgrade my call manager appliance from (ver 4.0 windows based)or i can keep using the existing onedoes the IPCC is compatable with ver 4.0 ? Please suggest..
Hi ,I think it show all the information about the trunk ports which is configured on the switch however i need to find only about the particular port. whether it is negotiated or not (with dot1q) I just translated the commands which you have posted o...
Hi Haddad,I found the commandsi think it should be like this set trunk 1/2 desirable set trunk 1/2 on dot1qsh port 1/2I think this the way is there any other options available to check this ?Thanks for your helpKrishna
