The customer is looking for a one click button for approving a guest. Right now the process is as follows:
Guest associates with the Guest SSID.Guest goes to sign up for a new user, inputs his/hers information and picks a sponsor then clicks Submit...
We have two BGP handoffs within the Data Center that is load-balancing and working fine. We have a MAN with 10 gig ethernet between the Campus and a remote office. We just installed a new BGP router and handoff at the Campus and running into obvious ...
I try:show mac address-tableshow mac address-table <anything else>The command just hangs on:#sh mac address-table Legend: * - primary entry, G - Gateway MAC, (R) - Routed MAC age - seconds since last seen,+ - primary entry using vPC Pe...
We are having some issues getting the QLogic QLE8142 to properly communicate to the Nexus 5020. We are not getting flogi messages (obviously vfc is not up). The CNA cards are coming up with a flashing green light and the ethernet interface is up on N...
I have an IBM Blade Server 'H' with HS21 blades. The servers have two gig interfaces. We are running bonding (method '0') with packet going out round robin. The connections are to the IBM/Cisco IGESM (Cisco ~2950) blade modules. We have trunk failove...
Both the ASA and PA support traffic shaping. This is actually a great feature to limit unwanted traffic too - if designed correctly.As with Cisco and Palo Alto, the higher end hardware will obtain better results for traffic shaping.Hope this helps!Ri...
The reference is incorrect Marvin. Can you recheck your source. I have the same question and need a source.I also need the sizing requirements and recommendations for the OVA.
I use Palo Alto firewalls extensively in the past and also have used ASA's since inception.Questions1) I believe the ASA 5585X would be right choice/equivalent: ASA5585-S10C10-K9. Correct?The correct firewall to size against the PA-3020 would be the...
The 'network 0.0.0.0' was recommended by our ISP. The 'default-information originate' command should accomplish the same thing.As far as the route-map, this is just used for our load balancer along with WCCP.Rick
The configuration guide is fairly confusing and you really don't know what you need to implement. Typically, I did the 'flow exporter' and found that obviously did not work. Here is what works now:flow exporter MGT destination x.x.x.x transport ud...