Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Folks,Could anybody please tell me how to assign limited command set to specific user ( group ). What I did in ACS Server1.Create a shell command authorization set.2. configure user to use just defined authorization set under group->shell command aut...
hi folks.I am able to login to my router VIA TACACS+ server. My username and password doesnot work with enable mode. When I do enable after login to user prompt; it just throws me "Authentication failed" message. AAA commands used aaa new-modelaaa au...
Folks,I tried to download flash image from a 2811 integrated service router using TFTP server. After downloading for a while, it says unknown error. I doubt it as file size limitation for TFTP, but not sure. Would any body please have any ideas for t...
What is service port interface in WiSM? I know it is used to communication with Supervisor Engine but just want to know in details ?Please helpthnxsubharose
hello folksI have 5 distribution/core switches running CatOS. I am trying to migrate them into IOS, infact changing whole supervisor engine with IOS firmware on it. Most of my data closet switch( access layer) running CatOs. Does it affects the the a...
Walter 1. Make sure you have MSFC module or not. 2. If you have, either issue session 15 or session 16 command in previleged EXE mode. if you installed only one MSFC then it should be session 15; else session 163. have user name and password for MSFC...
Well its pretty common but did you set up the IP address for default VLAN in the switch though? If you do and try to ping other computer with same VLAN ( default) if is working or not. hthsubharose
