Hello,I have my network with serie 300 switches. One is working in layer 3 mode and all others switches are in layer 2 mode.I dont have redundant path between switches. Should I enable STP? or is not necessary?Thanks a lot.

Hello,I need help. I have my network with severals SG300 switches.I have one of them like my core switch working in layer 3 mode. With 2 vlans and vlan interfaces to each vlan.Everything is working ok.But now i have to connect one 3com unmanage switc...

I setup switch SG300-52P in layer 3 mode.I have 3 vlans (10,20,30) and ports assigned to every vlan.Each host can ping its own gateway (depending the vlan).I want to permit some traffic from a vlan to an specific host (server) on another vlan. I try ...

I have to switches one in L3 an the other in L2. Several vlans on the network.Should i use a trunk connection between them or a etherchannel o port channel?what is the best way and when to use this options?thanks in advance for your answer.

I have to use 9 Cisco 300 serie switches to build a new network. I will use one of them (core switch) in L3 for routing between Vlans (3 Vlans) and the others in L2. Is there a software to centralized all switches configuration, operation and monitor...