Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi everyone, I have been experiencing a challenge that I really have not been able to figure out. I use a CT5520 WLAN controller with code version 8.10.150. At intervals, I realize that some of my APs just start downloading the software image from th...
I have an AP on my controller (3700i Aironet AP) lightweight showing its operational status as down. Further checks revealed the following as seen in the attached images; How do I enable the dot11 radio on the AP?
I have a stacked 3850 which is managed by Cisco prime infrastructure 3.4. I want to upgrade the IOS version. I successfully pushed the image from prime to the stacked device. Will activating the image from prime ensure that both switches in the stack...
Hi Everyone, I need a little bit of verification based on facts; I am aware that Cisco APs designated for my region (Nigeria) are the AIR-CAP3702I-E-K9 model APs. I want to find out if the model AIR-CAP3702I-A-K9 can be used here also. Cisco does not...
Hi Everyone, I have a mix of universal APs and AIR-CAP3702I-E-K9 in my wireless environment. I have successfully primed some APs manually and via NDP in my environment, but I have these set of APs that have remained unprimed. I have checked their pro...
@Sandeep Choudhary wrote:HI, Dont forget: Running wrong country code is illegal as well. Best case is, return the AP (with the wrong Regulatory Domain) to the vendor and ask them to exchange for the one with the correct Regulatory Domain. orRun the A...
I carried out all the steps prescribed. I used the Cisco Air Provision app to prime the AP and it showed that AP was successfully configured. Even with that, the AP is still shown as unprimed under Advanced and it carries the NG country code. It work...
@Sandeep Choudhary wrote:did you follow the steps properly!!! ..https://www.speaknetworks.com/cisco-universal-wireless-ap-provisioning-and-priming/ RegardsDontf orget to arte helpful posts I have tried the methods as stipulated in the link you s...
