Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Is Kron capable of dropping in commands in config mode? So far, I havn't been able to get this to work. I basically want to drop in a static route at a certain time, then remove it at another time.kron policy-list LAB-STORAGE-CONFIG cli configure t...
I have a simple question. I'm runing Cisco UCM 7.0.2 appliance, Cisco 3845 for my voice gateway, MGCP is the protocol. I have a single PRI connected to my voice gateway router and I'm basically migrating all DN's from the old carrier to a new carr...
When I do a sh interface on a switch or router, one of the lines reads output flow-control is XON, input flow-control is XON. Does anyone know of a reason you would want to turn this off? I actually thought that flow control is really decided/contr...
Let's say you have 2 identical 6500's under the same load, one running Advanced Enterprise, the other running Advanced IP. Will the CPU of the Advanced Enterprise switch average a higher utilization than the one running Advanced IP?
