Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
can someone clear following thing,
if we have following scenario and my ISP give me IP prefix 10.0.0.4/30, this prefix has total four IP address which of two is reserved one for sun-network address and one for broadcast address,
now my questio...
Hi,
When i ping to my network hosts, i got reply from my network hosts and there is a value in reply message and it's is TTL, when i ping to different devices in my network it's showing me different TTL values,even all device is in my same loc...
Hi,
I have create site to site VPN tunnel and here it the configuration of both router, but when i verify tunnel status using command show crypto session it's show status down, even everything looks ok and both router has reachability to each oth...
Hi,
Refer below STP scenario, Can someone tell me why switch-1 port Fa0/2 block and not port Fa0/1?
all switch has connected with fast-ethernet port, priority of all bridge is default. you all are see all switches MAC in attached snap.
also ...
Hi,
kindly someone give me the answer of this question and also brief description about correct answer.
Question: Which statements correctly define ACLs?
A. They can only be used on routers
B. They are used as a classification tool
C. They iden...
Hi Denial,
First of all thanks for such a classical explanation,
You said that holddown timer is not a part of RFC, then which timer have RFC for RIP2? and what are their timers?
Also why cisco introduced holddown timer?
Alpesh
...
Hi Richard sir,
As you said if will use PAT then IP address 10.0.0.5 is represent my local LAN mean it is my inside global address and address 10.0.0.6 will not used, am i right?
Thanks
Alpesh