Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi guys,I have recently upgraded Cisco PI from 3.8 to 3.9 and getting a pop-up message "Cisco Prime 3.9 Mandatory Oracle Patch is not installed. Please install the patch for the latest Oracle update. You may contact your System Administrator for furt...
Hi Experts,
I am trying to ssh into a device managed by our prime deployment. A new tab open in browser but not happen after that.
Any help be much appreciated.
Regards
Muhammad
Hi guys,
I am having an issue with incoming traffic from some ISPs. Any help be greatly appreciated.
Please see topology below.
Default route is coming in from both ISPs for outbound traffic.
As shown in diagram, i am advertising full range from ...
Hi folks,If i take off secondary ip address of interface vlan 1, most PCs looses network connection.All the PC's/Servers are pointing to 172.17.0.250 for their default gateway and have ip address from the same range 172.17.0.0/16here is what we got. ...
Hi,
We are in exact same situation as Mark. The link you provided above is taking to main 4500 page rather than step by step guide. Are you able to share the link again.
Thanks a lot
Muhammad
Hi Guys,
I have similar issue and wonder you could help?
(Cisco Controller) >show port summary
STP Admin Physical Physical Link LinkPr Type Stat Mode Mode Status Status Trap POE SFPType-- ------- ---- ------- ---------- ---------- ------ ------- ----...
