Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear All.I have 2 N5k running in vPC and there are 2 member N2k participating in vPC.Now I have a single server vlan in which there are around 30-40 servers running multicast applications.Now I need to enable multicast for these servers or rather for...
Dear All,Another issue faced by my team.We managed to install LMS 3.2 succesfully and all devices were reachable through LMS.We have AD present in our network, but whenever the request goes for AD authentication we are not able to succed in it.We fee...
Dear all,I have configured LMS 3.2 for network management and I am able to reach all devices.When I try to ping those devices I am able to reach each of them, but when I am trying to do the telnet I am not able to do the same.Is there any specific co...
Hello everyone,Can anyone assist me in performing stress and performance management using LMS 3.2We have a requirement where in we need to check how much stress our devices can cop up with, so need to perform some test using LMS. we heard that it ca...
There is problem with both external Wifi after power gets fluctuating Access Points not reachable through the network then we have remove power cable from Power Injector wait for 2 min and then plug it again. Then it will become on-line.Please guide....
Hi Joseph,Thanks for your valuable inputs, I need to understand one thing the monitoring of cpu you mentioned is it for the entire device or per port.Because when I was working on this I was able to receive only port utilisation reports no entire dev...
Hi all,I have been doing policy configuration on 6509 series switches for few days. And all of a sudden my 6509 started misbehaving, by giving surprizing results.I was configuring simple PBR policy (I edited the original policy mentioned above) whe...
Hi Marcin,Thanks for your reply.I understood your point so let me frame my question in better way to finalise this discussion.I am having one inside interface on ASA and I have 2 outside interfaces named outside1 and outside2.Lets say I have 192.168....
Exactly, "You also need to associate that tracking instance with the static route. " But this thing is not done in the doc provided by you, So just was curious how can we map in inside a static route?Please assist, thaning you in advance.Regards,Mang...
Dear Lei,Yes that is what I was actually looking for, I have another query which actually making me bite my nails and that is the command track 123 rtr 1 reachability.In my other post where we are using HSRP we are calling this track object 123, but ...
