Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HelloI'm really confused with a simple config.Outbound dial-peer doesn't match for call but matches for "csim start" and "sh dialplan".More detailed explanation.2851 with E1 PRI that should act as a VoIP gateway for inbound calls from PSTN to the SI...
Hello,I have got 7912 that stuck in the loop of Configuring IP, Configuring VLAN, Configuring CM List.Phone gets IP addresss, option 150, etc via DHCP.Phone is reachable by ping and I can open connection to the phone's tcp/80.I sniffed traffic from t...
Hello.Device discovery on the LMS 4.2.3 on the soft-appliance doesn't work yet.Task: not to add hosts manually or via bulk export, but discover hosts with ping and then add to the LMS.I started Custom Discovery.Just ping scan for a /27 subnet, no SNM...
Dear All,I have numerous Cisco ATAs 186 registered on the Callamanger 4.1. Hotdialing is configured with special CSS and Translaton Pattern that converts called number to the contact center number. Calls are routed via CUBE to the CUCM and than to th...
Dear All,I faced a very strange issue. All DNs in my CallManager have become marked as shared. Even DNs that exists only on one phone. Route Plan Report returns correct information but when I'm looking for line on every device, line is marked as shar...
Thank you for reply. I have solved the issue but in a little bit different way. I remembered about an option direct-inward-dial on inbound dial-peers. So, here is properly working config dial-peer voice 200 pots description ::: PSTN Leg Inbound Dial...
Thank you for reply. Here is the configisdn switch-type primary-net5!voice-card 0 dspfarm dsp services dspfarm!voice-card 1 dspfarm dsp services dspfarm!!voice call disc-pi-off!voice service voip allow-connections sip to sip sip header-passinginterf...
Dear AllI'm greatly appreciated for all answers.But solution or workaround for my issue was ridiculous. While operating with backups I have noticed, that lines are marked as shared only while accessing callmanger from windows7 box via IE 11. But line...
