Hello, I have multiple Cisco 3650's that I have no problems with, but I have one that will allow me to get to the gui but will not take the login and password. It gives me a "Wrong Credentials" error. I have searched the discussions on here and h...
I am currently using a Cisco SGE2010 switch, I have 4 rooms with each room assigned a separate VLAN and I have a separate computer that is used for maintenance and backup and it is assigned its own VLAN. All of these systems are in the same IP range....
I am working with a SGE2010 48 port switch, I have reset the switch to factory defaults and I am able to log in to the switch but I do not see any information on the System Information page of the WEB GUI...it is blank.I am able to access the switch ...
I am trying to change the IP on VLAN1 on a Cisco 2010 48 port switch. When I try to do this through the gui it will not allow me to change.If I go through CMD and use telnet, use ctrl z, enter lcli and try to change based on the commands I found here...
Thanks to all! I went and TELNET into the switch and discovered they had the switch set as a Layer 2 device. I changed it to a Layer 3, reset the switch, loaded the config and everything is working.
