Hi,I would like to have your help for an extension of a Cisco HyperFlex infrastructure.I have a Cisco HyperFlex UCS infrastructure consisting of 3 HX240c M5 and 2 UCS FI 6248UP. Now I have added 3 more HX240c M5 to extend the cluster.The firmware ver...
Hi, I have two UCS 6248up FI switches connected to the 3 HyperFelx UCS 240M5 nodes. For some time now I have noticed that the FAN LEDs are off. In addition, I have this error message:Fault Code:F1000227. Message. [FSM:FAILED]: sam:dme:EquipmentLocato...
I am install a HX cluster with a Cisco UCS 240c M5 and two fi 6332 16 UP on the Validations Overall step i have: Cluster Data IP Not Used "IP address: 10.19.9.10 at default port: 443 is reachable".None device uses the ip address 10.19.9.10 in the net...
Hi Makus,
I have a question.
In my architecture (3 nodes cisco HX C240c M5) + 2 UCS FI 6248up interconnected on my cisco switch Catalyst backbone. All my equipments are interconnected by SFP+ 10G (HX-node ---> Cisco FI ---> Backbone Cisco Catalys)
...
I have installed a HX-Cluster HX c240 M5 with 3 node (node1, node2, node3) they are no in production and I have not yet installed vCenter. My HX is interconnected by 2 UCS FI 6248up.
During installation I have choose 3 Replication Factor or I had to ...
In my architecture (3 nodes cisco HX C240c M5) + 2 UCS FI 6248up interconnected on my cisco switch Catalyst backbone. All my equipments are interconnected by SFP+ 10G (HX-node ---> Cisco FI ---> Backbone Cisco Catalys)
And I have 4 vlans in my Data C...
Hi Kirk J,
Thank you for reply.
I worked with the cisco TAC and we reinstalled the Esxi (for recreated the cluster) via Node KVM Console and after reinstalled the cluster by choosing 2 on Replication Factor and my probleme is solved.
Thank,
