Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,Wanted to download the latest firmware for a IE-2000 switch (not IE-2000U), but it has been removed from the download page on Cisco support.
These models went End-of-Sale 5 days ago, but they are supported until 2029. So, I guess someone was to...
For anyone looking for an answer to this.
Google did not help me with this problem, so I will share the solution here.
I just installed a IR1821 router at a location, the local ISP delivered fiber directly to the router with a BiDi SFP, GLC-BX-U sing...
I had a strange discovery recently that I have tested a little today. Is this a bug or do I need more configuration to make this work? I have a client connected to a switch (IE2000) that is again connected to a router with a trunk, and this router ha...
Just a heads-up if other people look for a solution to this.Installed new IOS version 15.8(3)M2a to an IR809 router, and when adding it to the NMS I started to get these messages:%SNMP-3-INPUT_QFULL_ERR: Packet dropped due to input queue fullFound so...
I wanted to implement FirePOWER rules based on AD groups so I installed and configured the FirePOWER User Agent. But it seems like the dual stack network ruins this solution, the AD authentication that is picked up by the User Agent and sent to FireS...
This is old, but I came across it when searching for something similar.First, when doing telnet with a FQDN and the dns call resolves an IPv6 address it will try that. So if your network does not have IPv6 then use the /ipv4 flag to the command:telne...
I see no one have answered you, and even if I have not used it myself I saw there is a configuration for doing this, at least using ftp on a router type I use. Check out if you find something like this on your router ("0" may need to be something els...
Hello Harold, thank you for the reply. OK, I checked this. As suspected it was off by default. I enabled it globally and disabled it on this VLAN, but with the same result. Default on this IE2000 switch: sh run all | in mldipv6 mld snooping listener-...
Hi Nathan, I see that you never got an answer to your question. This is for others googling a solution to this problem. My experience to this is that the internal electrical system on this alarm input is different from router to router. Some of them ...
