Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Why is the crashinfo file found on the new switch?Crash info can vary in capacity.4096, 8192, 36000You mean the 36000 switch is even more problematic?The contents of the tracelog folder of CrashInfo are as follows.9200L switch crashinfo question. Swi...
Hello.We have configured port forwarding and it works fine.1. Port forwarding from the external Internet to the internal server, OK2. Port forwarding from the external Internet to the domain address of the internal server, OK3. Access to the internal...
Hi 'show arp' shows the IP and port registered in the arp table.Is there a command to scan the IPs of the devices connected to the switch like the application program IPSCAN? Thanks
HiI want to see the following packet in a switch debug command.But it didn't work.Communication between devices is good. case 1192.168.50.2 -> 192.168.50.1192.168.60.2 -> 192.168.60.1At this time the ICMP debugs were collected successfully. Case-2192...
Hello There is a site where a wireless environment was built with CT3504 (users are factory equipment). All AP power levels are at their maximum (it is said to be difficult to lower because the strength at which the client receives signals is not str...
HelloI tested 100 new 9200Ls, and when I used the dir crashinfo command all the equipment was there.However, some devices were 4096 bytes and some were 36000 bytes.It seems normal to have such a small amount of crashinfo information.I was wondering i...
Hi Yes, I couldn't find the IP simply by pinging the broadcast address.I am wondering if there are any additional settings that need to be made. Thanks
1.But as per the configuration the VLAN has .2 IP adress as below:Sorry, the diagram and IP have changed for the first time.I will attach the modified diagram again.Port 1 PC-50.3Port 2 PC-60.3Ping from 50.3 to 50.2/60.2 creates a logPing from 60.3 t...
