About Melvinb1981

Melvinb1981 · 04-18-2020

you missed one command on this. you need to set ip routing on the layer 3 switch else you dont reach...

Melvinb1981 · 04-18-2020

Good Day, Is it possible to carry vlan traffic across a layer 2 etherchannel switch to a multilayer ...

Melvinb1981 · 01-18-2020

Thanks for the reply, What i am getting at is using gre over ipsec as that supports multicast correc...

Melvinb1981 · 01-18-2020

Good Day, In what scenario would you ever configure just a GRE tunnel between Branches without IPSEC...

Melvinb1981 · 01-16-2020

Thanks for the reply. I would not be able to use vti unless both routers are Cisco correct? Regards

Melvinb1981 · 01-16-2020

Good Day, To make use of a Site to Site connection between HQ and a Branch office am i correct in sa...

Melvinb1981 · 01-12-2020

Good Day, Im not certain if this is just related to packet tracer as I have not tested this yet on l...

Melvinb1981 · 01-01-2020

Good day, Can you negate VTP once enabled ? It doesnt seem like it? The only option seems to be to a...

Melvinb1981 · 09-22-2019

Hello, The Fibre cables goes to the white box, RJ45 then to the Calix Box. Wan Port.I cloned the MAC...

Melvinb1981 · 09-22-2019

Hi,The top box in the pic is the ont box where the fibre goes into. It thenruns the rj45 cable to th...

Melvinb1981 · 09-22-2019

844e-2

Melvinb1981 · 09-21-2019

Yee correct its a calix

Melvinb1981 · 09-20-2019

Hi , Sorry was shutting the port down then up again for testing and copied over the code before i br...

Melvinb1981 · 09-20-2019

Hello,Below is default and i manually changed the config to full duplex as well still no joy. I beli...

Melvinb1981 · 09-19-2019

Router#showJan 2 12:07:52.775: %SYS-5-CONFIG_I: Configured from console by consolepppoe session1 cli...

Re: EtherChannel from Layer 2 Switch to Layer 3 multilayer Switch VLAN Trunking