Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I cannot configure service policy on a Layer 3 portchannel on ASR 1004 with Cisco IOS XE 3.5.1, in which is supposed to be supported. This the information that i had:access-list 1 permit ip any host xxxx time-range LAN-time!class-map match-any ...
Dear all,I looking in the data sheet of the virtual interface card at the link below.http://www.cisco.com/en/US/prod/collateral/ps10265/ps10280/data_sheet_c78-525049.htmlCould you assist me in finding out is the Cisco UCS M81KR supports IEEE 802.3ad ...
Hello,I want to have 6509 with VSS sup 720 and PFC 3C with 1 GB for RP & SP each. I am planning to install WS-X6704-10GE with CFC and default onboard memory 256 MB. I found out that I would not have any problems between VSS and the line card accordin...
Hello all,I am experience the following issue: In an environment with Cisco and other vendor swithces (HP Procurve), we receive an IP conflict on the servers.I inspect the logs from 6500s and I found out this message:%IP-4-DUPADDR: Duplicate address ...
Hello,
Please be so kind to assist me on the following questions:
1. In vPC VTEP scenario with MP-BGP EVPN VXLAN do we need to have the vPC peers to be BGP adjacent? if YES, why we need this adjacency?
2. Can you explain why we need VRF overlay VL...
