Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am trying to connect 2 ASA 5525-X devices, one pure firewall and one pure IPS with Firepower services. I was wondering if I needed to create a new P2P IP addresses to connect the two together? or if the data is purely pass through. I know that t...
I am trying to connect 2 ASA 5525-X devices, one pure firewall and one pure IPS with Firepower services. I was wondering if I needed to create a new P2P IP addresses to connect the two together? or if the data is purely pass through. I know that t...
All,
I have 2 Catalyst 6500/Cisco 7600 Supervisor 720 Fabric MSFC3 PFC3B Modules, one main and one redundant one. I am noticing some errors when I bring it up in the console as I try and make the second on a hot spare. It currently says cold, rpr s...
I have 2 ACS 5.5 units (1 primary, 1 secondary) and I am trying to configure the failover capabilities between these devices. So far, if the primary goes down, the secondary does not pick up the devices and I loose connectivity with those devices. ...
I am having the same issue, but only after a diagnostics test. It boots correctly after a power failure, but not after i use the command line. If i use the command line: switch#reload; it says the switch is not enabled for automatic booting. Howev...
