Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I would appreciate pointers or information that will help me identify UCS-5108 blade server and physical ethernet interfaces based upon a Veth#### value I get via CLI or SNMP from a UCS FI 6248. For example, using the command 'show mac address-table ...
I'm having a debate with other network engineers about the benefits of using load balancers at the Data Center. The client requires N+1 redundancy at the datacenter, which means we'll need to deploy four WAVE 7471 devices at the main datacenter, and ...
Hello everyone,I'd appreciate feedback on existing MPLS service providers. Their strenghts and weaknesses, footprint and Service offerings. I am about to start a project with Equant and Level-3, your comments and general observations are welcome.TIA,...
Hi everyone,Just wondering if any lower end Cisco models including the 2500 series or lower models are capable of running MPLS as customer edge (CE) devices. A quick search on CCO for IOS releases that support MPLS fails to list anything lower than 2...
Padma,Thank you for the reply. It helps. I also contacted a Cisco TAC engineer, and got a reply with valuable information. It turns out that the Cisco UCS FI 6248 is quite similar to a Cisco Nexus 5500. I can use similar CLI commands and verify Virt...
IGX switches' OS have various access levels. Up until OS Version 9.X, the highest Customer access level was SERVICE. Cisco had a higher access level STRATACOM. STRATACOM level could SEE all the other level passwords.Likewise SERVICE level access coul...
Srini,The mrtg.cfg file you just created should look similar the the following lines at the beginning of the file:# Created by # cfgmaker [email protected] --global 'WorkDir: c:\www\mrtg' --output mrtg.cfg### Global Config Options# for UNIX# W...
