No Ni, The IE 4000 datasheet states that your model supports up to 8 PoE/PoE+ ports and that it is "designed to support PoE power budget up to 240W". However, further down in the same document it says that the biggest available power supply can only ...

JPauschert, Even with the password recovery feature disabled, you should still be able to access rommon. The caveat is that this will erase your configuration. Try connecting to the console, booting the device, and entering the break sequence. You sh...

Jason, Your VSS looks OK, but I still wouldn't rule out VSS quirkiness. Is it possible to physically connect to the console port of the active switch? If you can and issuing the ECP command still fails, then I would contact Cisco TAC.

Gavin, Check out the relevant Cisco Validated Design Guide.

That is correct.