Hello,I would like to be able to bridge two ports in the same xconnect domain. I can't do it and wonder if it is possible to do it ?I tried the configuration below on an ASR 1000 :interface GigabitEthernet0/0/0 no ip address negotiation auto cdp e...

Hello,Can you tell me if it is possible to reduce the switchover time of an Xconnect in backup peer mode ?On a router I use xconnect (l2tpv3) to a primary router and backup peer to the secondary router :interface GigabitEthernet0/0/1no ip addressnego...

Hello,I want to use the backup peer function with Xconnect (I tested on 892FSP, 921, ASR1001).I realize that the command is not available even with a pw-class in L2TPv2 and L2TPv3 or MPLS.LAB-01(config-if)#backup ? active Configure an interface...

Hello,I cannot authenticate my CPE on my LNS. The L2TP tunnel seems to work.interface Dialer0 ip address negociated encapsulation ppp dialer-group 1 ppp authentication chap callin ppp chap hostname test@cisco.lab ppp chap password 0 test123 end...

Hello,I have an 819G-4G router with IOS c800-universalk9-mz.SPA.159-3.M7.bin.If I use a SIM card without a PIN code I cannot establish a connection :Router#sh cellular 0 securityActive SIM = 0SIM switchover attempts = 0Card Holder Verification (CHV1)...