Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I am getting below error after powering ON the switch. I have also attached the logs file for complete logs review.CISCO SWITCH Ver7.17Device detected on 0:6:0 after 0 msecsDevice detected on 0:1:1 after 0 msecsDevice detected on 0:1:0 after 0 mse...
We have cisco DX650 phones in one office and Avaya Vantage K175 in other office. We are trying to connect over Video call but it is not connecting. Is there any compatibility issue for not connecting Video?
We have cisco SX20 unit in office. The problem with this unit is , the call logs timing is showing on UTC even after setting the time zone as Asia/kolkata.
Hi,
We have approx. 1400 phones in our office and all are registered on same call manager. There are 3 phones which are behaving weird. These phones are dialing the numbers by its own, last dialing number is connecting.
We have hard reset the phone...
Hi,
We are planning to configure SIP trunk between our India and Australia offices. We have cisco clusters across both locations. Also we have firewall setup at one location in network. Please can any one help us with port details required to be op...
Thank you all for your reply.
So trigger busy 1 is working fine for our phone model 7841 but this setting is not working for DX650 model phones even after setting trigger to 1. 2nd call is receiving even the line is busy on other call.
