Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Greetings Community! I am having an issue with one-way audio from our remote office Phone to our HQ, so the problem is that on calls (inbound, outbound) we get no audio from the Phone that resides on one of our remote offices (meanwhile other offices...
Greetings Community, I am having an issue with calls coming from the ITSP towards my CUBE, the setup is: ITSP-> FTD FW -> CUBE <-> CUCM <-> IP PHONEI try calling from my mobile phone to my IP Phone's DN, so I dial the DID number that the ITSP provid...
Greetings! I have an issue with calls coming from the ITSP, they gave us two DID Numbers and the format that they send that number towards us is +38xxxxxxxxx.So, I'm having problems with this because this format isn't supported by CUBE on it's transl...
Greetings Community, Is there any way for traffic to failover to local network after the connection to WLC fails.Right now I have Central Authentication with Local Switching and when i shut down the connection from WLC to AP the hosts that are alread...
Greetings, I am facing an issue with CSSs and Partitions, when I try to add any new partition into my existing CSS I get one error:Update failed. The list of Partition names (Clause) in a Calling Search Space is too long as a result of this operation...
If I understand this right, what I need to do on my FTD is configure Destination NAT ( translate the destination IP Address from my FW outside IP as can be seen above, to my CUBE-s IP address which I use to bind the media and control), is this right?...
Greetings @Roger Kallberg !Thank you very much for the reply, that translation rule did work for me, I am so sorry for the late reply and also for not providing the right information upfront, I will try my best in the future thanks a lot for the advi...
@Roger Kallberg It is as @Nithin Eluvathingal explained, I need that call to be directed toward my deskphone's Extension.And to be able to do that, I will need to have a translation profile which translates +38xxxxxxxx to for example 77600 (IP Phone...
Hi Roger, thank you a lot for your reply! The problem is that I want to translate this number +38xxxxxxxxx (as this is the format the SIP Provider sends us) directly to the DN of my operator, would that be possible?
