06-10-2004 08:43 PM
I have a AS5300 running VOIP call without Gatekeeper(GK) now. Can i select (settings) some dial-peer plan to communicate to a particular GK. And the rest of the dial-peer will remain as per direct route as it is now ?
If yes, how should i do so?
Thanks,
Solved! Go to Solution.
06-11-2004 12:14 AM
Yes you can.
You have to configure the GK correctly on the GW, verify the succesfull registration and then you can combine the dial-peers as usual as per example below:
dial-peer voice 2 voip
incoming called-number .
destination-pattern .T
voice-class codec 100
session target ras <- going to configured GK
dtmf-relay h245-alphanumeric
fax-relay ecm disable
fax rate 9600
fax nsf 000000
fax protocol t38 ls-redundancy 1 hs-redundancy 1 fallback none
!
dial-peer voice 13 voip
preference 4
destination-pattern 072.......
session target ipv4:217.19.0.22 <- specific GW1
!
dial-peer voice 14 voip
preference 5
destination-pattern 074.......
session target ipv4:217.19.0.16 <- specific GW2
etc...
06-11-2004 12:14 AM
Yes you can.
You have to configure the GK correctly on the GW, verify the succesfull registration and then you can combine the dial-peers as usual as per example below:
dial-peer voice 2 voip
incoming called-number .
destination-pattern .T
voice-class codec 100
session target ras <- going to configured GK
dtmf-relay h245-alphanumeric
fax-relay ecm disable
fax rate 9600
fax nsf 000000
fax protocol t38 ls-redundancy 1 hs-redundancy 1 fallback none
!
dial-peer voice 13 voip
preference 4
destination-pattern 072.......
session target ipv4:217.19.0.22 <- specific GW1
!
dial-peer voice 14 voip
preference 5
destination-pattern 074.......
session target ipv4:217.19.0.16 <- specific GW2
etc...
06-11-2004 02:26 AM
Thanks alot, i will try this out.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide