AS5300:Only selected destination-pattern communicate to a Gatekeeper.

[anthonylee]

I have a AS5300 running VOIP call without Gatekeeper(GK) now. Can i select (settings) some dial-peer plan to communicate to a particular GK. And the rest of the dial-peer will remain as per direct route as it is now ?

If yes, how should i do so?

Thanks,

[dragos.stroescu · Accepted solution]

Yes you can.

You have to configure the GK correctly on the GW, verify the succesfull registration and then you can combine the dial-peers as usual as per example below:

dial-peer voice 2 voip

incoming called-number .

destination-pattern .T

voice-class codec 100

session target ras <- going to configured GK

dtmf-relay h245-alphanumeric

fax-relay ecm disable

fax rate 9600

fax nsf 000000

fax protocol t38 ls-redundancy 1 hs-redundancy 1 fallback none

!

dial-peer voice 13 voip

preference 4

destination-pattern 072.......

session target ipv4:217.19.0.22 <- specific GW1

!

dial-peer voice 14 voip

preference 5

destination-pattern 074.......

session target ipv4:217.19.0.16 <- specific GW2

etc...

[anthonylee]

Thanks alot, i will try this out.