Dear All,
I have some issue with call not connect when making new trunk with another partner which using SIP protocol port:5061 or 5062.
I am using AS5400XM and my existing partner were using port 5060 as default SIP port already. And i want to get new partner which require
SIP protocol with port 5061.
Is there anyway to change default port of SIP protocol from 5060 to 5061 or 5062 for Incoming/receive call or originate call on VOIP leg in dial-peer mode?
Below is my AS version.
Cisco IOS Software, 5400 Software (C5400-IS-M), Version 12.4(11)T4, RELEASE SOFTWARE (fc3)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2007 by Cisco Systems, Inc.
Compiled Fri 26-Oct-07 23:35 by prod_rel_team
ROM: System Bootstrap, Version 12.3(12r)PI6b, RELEASE SOFTWARE (fc1)
abc-01-abczz uptime is 1 year, 8 weeks, 4 days, 4 hours, 13 minutes
System returned to ROM by power-on
System restarted at 09:34:30 GMT Wed Dec 22 2010
System image file is "flash:c5400-is-mz.124-11.T4.bin"
Cisco AS5400XM (BCM) processor (revision 0x22) with 393215K/131072K bytes of memory.
Processor board ID JAE1212BSYD
SB-1 CPU at 750MHz, Implementation 1025, Rev 0.3, 256KB L2 Cache
Last reset from power-on
Manufacture Cookie Info:
EEPROM Version 0x4, Board ID 0x4BD,
Board Hardware Version 2.7, Item Number 800-6572035-03,
Board Revision A0, Serial Number JAE1212BSYD.
Processor 0x0, MAC Address 001e.13d1.0d48
2 Gigabit Ethernet interfaces
507 Serial interfaces
492 terminal lines
16 Channelized E1/PRI ports
512K bytes of NVRAM.
125440K bytes of ATA External CompactFlash (Read/Write)
Configuration register is 0x101
Regards,
Dan
