Channelized E1 Line Code Violations

[marman]

Hi,

I`m getting the following output from one of my E1 ports on my C3662 - the other one is clean. I was wondering if anyone knew what a Line Code Violation was and if these cause voice problem (i.e call drops).

Total Data (last 24 hours)

48 Line Code Violations, 51 Path Code Violations,

0 Slip Secs, 0 Fr Loss Secs, 48 Line Err Secs, 0 Degraded Mins,

48 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs, 0 Unavail Secs

Cheers

[marman]

Further to the message before. There are errors on the interface. Can anyone assist? Would a shut no shut help?Ta

Serial5/0:15 is up, line protocol is up (spoofing)

Hardware is DSX1

Description: **** Meridian PRI-Loop 31 ****

MTU 1500 bytes, BW 64 Kbit, DLY 20000 usec,

reliability 255/255, txload 1/255, rxload 1/255

Encapsulation HDLC, loopback not set

Last input 00:00:04, output 00:00:04, output hang never

Last clearing of "show interface" counters 1w0d

Input queue: 0/75/0/0 (size/max/drops/flushes); Total output

Queueing strategy: weighted fair

Output queue: 0/1000/64/0 (size/max total/threshold/drops)

Conversations 0/1/256 (active/max active/max total)

Reserved Conversations 0/0 (allocated/max allocated)

Available Bandwidth 48 kilobits/sec

5 minute input rate 0 bits/sec, 1 packets/sec

5 minute output rate 0 bits/sec, 0 packets/sec

227671 packets input, 1889955 bytes, 0 no buffer

Received 0 broadcasts, 0 runts, 0 giants, 0 throttles

0 input errors, 53 CRC, 0 frame, 0 overrun, 0 ignored, 0 a

262101 packets output, 2479036 bytes, 0 underruns

0 output errors, 0 collisions, 0 interface resets

0 output buffer failures, 0 output buffers swapped out

7 carrier transitions