I have a 1750 router here with a VIC-2FXO-M1 card. Upon bootup, with the card in any slot, I received:
00:00:05: %PQUICC-1-UNKNOWN_WIC: PQUICC(0), WIC card has an unknown ID of 0x2B
I went through the Cisco tool to select the IOS I needed and installed c1700-sv3y-mz.122-27.bin so I'm now on:
IOS (tm) C1700 Software (C1700-SV3Y-M), Version 12.2(27), RELEASE SOFTWARE (fc3)
I still get the "unknown ID" error even though the tool at http://tools.cisco.com/Support/Fusion/FusionHome.do said it was supported.
Am I using the wrong IOS? I reset the thing to factory defaults and reloaded to find the same error.
Router>show version
Cisco Internetwork Operating System Software
IOS (tm) C1700 Software (C1700-SV3Y-M), Version 12.2(27), RELEASE SOFTWARE (fc3)
Copyright (c) 1986-2004 by cisco Systems, Inc.
Compiled Tue 02-Nov-04 18:36 by kellmill
Image text-base: 0x800080E0, data-base: 0x80B2B198
ROM: System Bootstrap, Version 12.0(3)T, RELEASE SOFTWARE (fc1)
Router uptime is 8 minutes
System returned to ROM by reload
System image file is "flash:c1700-sv3y-mz.122-27.bin"
cisco 1750 (MPC860) processor (revision 0x601) with 36864K/12288K bytes of memory.
Processor board ID JAD05041B3X (3666672781), with hardware revision 3097
M860 processor: part number 0, mask 32
Bridging software.
X.25 software, Version 3.0.0.
1 FastEthernet/IEEE 802.3 interface(s)
32K bytes of non-volatile configuration memory.
8192K bytes of processor board System flash (Read/Write)
Configuration register is 0x2102
