cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
650
Views
0
Helpful
1
Replies

configuring BRI interface for Voice ( MGCP gateway

noc-au
Beginner
Beginner

hi there,

i have a Call Manager which is connect to Cisco 2800 series acting as MGCP getway. ISDN connection between the 2800 and the carrier ( telestra sydney ). the call manager is seeing the gateway and i have configured a numbering plan on the call manager for the phones. the phones can call internally but externally i dont what configuration i should configure under the BRI interface for the carrier ( telestra ) to recongnise my number plan. please if you have any demo configuration or configuration that has perviously used post to me.

1 Reply 1

dford333
Beginner
Beginner

this is a basic MGCP config on the Gateway on your area

BRI Switchtype Information

BRIs in Australia require no service profile identifiers (SPIDs).

There are two ISDN switch-types that can be used:

basic-net3?Currently the most commonly used.

basic-ts013?For older ISDN switches such as MicroLink.

isdn switch-type basic-net3 or 5

voice-card 2

dspfarm

dsp services dspfarm

controller T1 2/0

description T1 link to SRST

framing esf !--- Automatic method automatically adds

clock source internal

linecode b8zs !--- Automatic method automatically adds

cablelength short 133

pri-group timeslots 1-2,24 service mgcp !--- Automatic method

!--- automatically adds 24 channels.

!---You can manually edit channels.

description T1 link to SRST

interface Serial2/0:23

no ip address

isdn switch-type primary-ni !--- Automatic method automatically adds

isdn protocol-emulate network !--- Simulated Lab ISDN

isdn bind-l3 ccm-manager !--- Allows all Q931 to be backhauled over TCP to

!--- CallManager; automatic method automatically adds

no cdp enable !--- Automatic method automatically adds

!

!

ccm-manager mgcp

ccm-manager music-on-hold

ccm-manager config server 171.69.103.225

ccm-manager config !--- Enables automatic config download from CallManager

!

!--- Automatic method automatically adds these commands

mgcp

mgcp call-agent 171.69.103.225 2427 service-type mgcp version 0.1

mgcp dtmf-relay voip codec all mode out-of-band

mgcp rtp unreachable timeout 1000 action notify

mgcp modem passthrough voip mode nse

mgcp package-capability rtp-package

mgcp package-capability sst-package

no mgcp package-capability fxr-package

mgcp package-capability pre-package

no mgcp timer receive-rtcp

mgcp sdp simple

mgcp fax t38 inhibit

mgcp rtp payload-type g726r16 static

!

mgcp profile default

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers