Re: Hairpinning on 2821 - critial problem

cgregg · ‎01-18-2005

I can not seem to get my 2821 which is acting as my CME and Gateway to pass off inbound calls. I can make outbound calls.

I believe I am having a dial-peer issue.

Can anyone help with suggestions, links for sample configs.

Thanks in advance,

Curt

Aaron Harrison · ‎01-19-2005

Can you give more info - where can't you get inbound calls to go from/to? from pstn to voip, voip to voip, voip to pstn?

Thanks

Aaron Please remember to rate helpful posts to identify useful responses, and mark 'Answered' if appropriate!

cgregg · ‎01-19-2005

I'm not sure its Hairpinning but, I have 1 router which is providing CME\CUE\Gateway with 12 FXO lines. I can make VoIP calls to the PSTN thru the Gateway.

I can not recieve calls from the PSTN. The FXO port lights up and then disconnects.

I believe I am having Dial-peer issues.

vcornett · ‎01-19-2005

Do you have your codec set to G711?

Aaron Harrison · ‎01-20-2005

Can you post your dial-peer and port configs?

Aaron Please remember to rate helpful posts to identify useful responses, and mark 'Answered' if appropriate!

cgregg · ‎01-21-2005

It seems like I am having a Dial-peer issue. Here is my orginal Dial-peer plan. I have since then tried different methods.

This plan is very similar to another installation I am running with 1 router for CME and 1 router for my gateway. and I have only specified the codec under my dial-peers.

I have a PVDM2-16 and 48.

Thanks