VOIP calls not being forwarded from GW to GK and visa versa

[melhajj123]

I have a VOIP network setup in place using 2691 routers. i have a siemens PBX connected to the 2691 routers using an E1 controller (running QSIG), my WAN interface between the two sides is an ATM interface. when i do a csim start from one router to the extension on the other side the call goes through and the phone rings. However, when i actually dial from one extension to the other, the call is not being forwarded. and what happens is that i hear the dial tone again on the phone im dialing from.

I have taken some debugs but still could pin point the problem, even though in the ccapi inout debug i found that when it tries to look for a node, it doesnt find it.

I have attached the configuration for both sides. Along with the debug from one of the sites.

There are a couple of GW's associated with the GK.

The ones im concerned about are Mussalla_GW & GK-HO.

Thank You in advance

Mouhannad

[melhajj123]

the ccapi debug

[dgahm]

Try this:

dial-peer voice 2 pots

direct-inward-dial

Without this command the router will not collect the digits coming across the PRI.

Please rate helpful posts.

[melhajj123]

Thank You very much for your help, this solved the problem.

How did i miss such a thing