Our UC560 which has been strumming along for a little over 2 years with no changes to our environemnt, or our uc560 (including firmware / software pack upgrades/etc).. has just now started refusing connections via ssh/telnet/cca as well as phone calls/etc.. if I power cycle the UC560 everythings fine again for about 24 hours.. then I can no longer CCA/SSH into it.. and users cannot make IP calls between sites.. calls out of the PRI are fine.
This leads me to believe something may be wrong on one of the NIC's.. but I have absolutely no idea where to even start as far as debugging goes.. can anyone assist?
