Corlist on UC500

[wbourguibartic]

Hi all,

I have question regarding steup corlist on Cisco UC500 with CLI.

Outgoing calls are routed via a SIP trunk from a generic SIP provider.

There is my config :

dial-peer cor custom
name national
name gsm
name international
name urgence
!

dial-peer cor list droits-limites
member national
member urgence
!

dial-peer voice 1015 voip
corlist outgoing droits-limites
description Appels Locaux
translation-profile outgoing OUTGOING_TRANSLATION_PROFILE
preference 1
destination-pattern 0[1-59]........
session protocol sipv2
session target sip-server
dtmf-relay rtp-nte
no vad
!

ephone-dn  4  dual-line
number 847
label 847
description TOTO
name TOTO
allow watch
corlist incoming droits-limites
transfer-mode consult

!

I have another dial-peer with no corlist configured.

When i make an outgoing call, It match with dial-peer wich have no corlist configured.

have you any idea ?

Thanks all.

[Steven Smith]

Does the other dial peer have a perference of 0 (which would mean no preference)?

If you do not have a cor list configure on the ephone-dn or the dial-peer, they are available to anyone.

Here is all the information you need to know about the subject.

http://www.cisco.com/en/US/tech/tk652/tk90/technologies_configuration_example09186a008019d649.shtml

[Joseph Chambers]

You will need to apply to all dial peers if you want to restrict access.

I've attached something - its for US but you should be able to see correlation.

[wbourguibartic]

Hello,

Thanx for response guys, I had no time to configure it.

I will test it and give response asap.

Best regards.