Dial-peer not working with .T

[jmmoralesf]

Hi everyboy ! I have the an UC560  with a small problem   I created a dial-peer like this

dial-peer voice 8 pots

corlist outgoing call-international

description Internacional

translation-profile outgoing Strip7

destination-pattern 700T

port 0/1/3

forward-digits all

The problem is that it' doesn't  work I  check with 

Ni.Pbx#sh dialplan number 70045646546548( fictional number)

Macro Exp.: 70045646546548

No match, result=1

If I change the destination-pattern to something like 700.....

the sh dialplan number works , but the calling doesn't receive all the digits.

Any Ideas ?

Thanks in advance

[paolo bevilacqua]

Try

no translation-profile outgoing Strip7

destination-pattern 7[0][0].....T

default forward-digits

[jmmoralesf]

I still have the same result :

sh dialplan number 700130565683255

Macro Exp.: 700130565683255

No match, result=1

sh dialplan number 70056225232160

Macro Exp.: 70056229232160

No match, result=1

[paolo bevilacqua · Accepted solution]

sh dialplan number 70056225232160 timeout

[jmmoralesf]

Thanks it finally work , but I have to  put back the translation-profile outgoing Strip7

Anyway thanks for your help

[paolo bevilacqua]

When destination-pattern and forward-digits are configured correctly, no translation-profile is needed.

Thank you for the nice rating and good luck!