1 Accepted Solution
Accepted Solutions
You want to reset the SPA112 to factory reset, then follow below procedure.
This method will perform a full firmware level restore to defaults. In other words, it will restore Both Network configurations AND Voice configurations.
- Using the end of a paperclip, press it into the red hole marked RESET, located on the bottom-left side of the back panel of the SPA112. Press and hold for at least a full 10 seconds. Cisco documentation is currently stating to hold as much as 20 seconds. 10 seconds is working for me.
SPA112_Rear.jpg (10.46 KiB) Viewed 8718 times - Power LED will start to blink when the restore process begins.
- Power LED will continue to blink for a total time of ~ 150 seconds.
When the power LED stops blinking (after ~ 150 seconds, or 2.5 minutes has elapsed), you should be able to log back into the SPA112, if desired.
NOTE:
The rear-panel RESET button (Factory Restore feature) can be disabled by logging-in as Administrator, and then navigating to the Administration menu and selecting the Reset Button menu option. By default, the rear-panel RESET button is Enabled. (This option only affects system restores; not reboots)
Final Note:
- If you only want to restore Network settings OR Voice settings back to default values (but not both), you will need to use the Cisco Configuration Utility procedure outlined in method 2using your web browser access.
