04-12-2010 09:34 AM - edited 03-21-2019 02:25 AM
Have another issue where certain FXOs just lock up. The LEDs on the UC shows an active call but there isn't one. Port sum shows weird statues - I'm trying to find my debug logs. I have to shut / unshut the FXO so that calls can go through. I have opened a ticket with TAC but this still remains unresolved. Anyone out there seen this? Thanks again - Carson
04-12-2010 09:37 AM
This sounds like a typical FXO disconenct problem. More info on:
http://www.cisco.com/en/US/tech/tk652/tk653/technologies_tech_note09186a00800ae2d1.shtml
Thanks,
Marcos
04-12-2010 09:54 AM
Not sure how typical this is Marcos I've had two different TAC cases open and it still isn't resolved. There is something else going on. Or if not, how do I know when to use supervisory disconnect signal or battery-reversal? And how come TAC hasn’t suggested that?
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide