FXS/Analog phone auto-dial when picked up?

[Jeff Cooper]

Hello.  UC540 862.  I have a door intercom i have patched into the phone system via FXS port (will not use FXO).  When the button is pressed on the door intercom, you get a dial tone over the speaker and the FXS port is open.   Is there a method to have it auto-dial an extension?   I've setup lobby phones that intercom a specific phone internally, but in this case, i need it to autodial a main hunt group- ext 101, which blasts 4 people.  Unfortunately the door unit does not have a dial-pad.

Thanks in advance.

[paolo bevilacqua]

ephone-dn xx

intercom

[Jeff Cooper]

to verify per my question, i can use in the intercom command above as any extension on the phone system without any intercom related configuration on the target extensions

so as above :

intercom 101 will ring the call-blast group

?

thanks

[paolo bevilacqua]

You can use any valid destination you desire.

Please remember to rate useful posts clicking on the star below.

[Jeff Cooper]

didn't work but again - fxs port as it's not compatible with fxo port ..  (below readout).. trying connection plar 101.. maybe that'll work

KMK-UC540(config-voiceport)#do show voice port sum
                                           IN       OUT
PORT            CH   SIG-TYPE   ADMIN OPER STATUS   STATUS   EC
=============== == ============ ===== ==== ======== ======== ==
0/0/0           --  fxs-ls      up    dorm on-hook  idle     y

KMK-UC540(config-voiceport)#voice-port 0/0/0
KMK-UC540(config-voiceport)#intercom 101
                              ^
% Invalid input detected at '^' marker.

KMK-UC540(config-voiceport)#int ?
% Unrecognized command
KMK-UC540(config-voiceport)#

[paolo bevilacqua · Accepted solution]

You did not specify if you are using the voice port in SCCP mode (UC500 default), or not.

For SCCP mode, configure intercom under ephone-dn.

Otherwise, configure connection plar under voice-port.

[Jeff Cooper]

both ways worked great

thank you!