It would have to be when CCA supports creating SIP end points, and you would need to see a development road map on when that is going to happen, right now I am not aware of any transparency in this road map, and IF Arthur or any of the other Cisco team members have access to this, it would also be good to know what version of CCA will support this.
(PS) You can get it to work via CLI but CCA will not be all to happy about it, so if it is a CLI managed system and you will never need to use CCA then it is already possible
Cheers,
David.
Cheers,
David Trad.
**When you rate a persons post, you are indicating a thank you or that it helped, but at the same time you are also helping to maintain the community spirit - You don't have to rate posts and you wont be looked down upon :) *
